User Manual

Getting Started

Read Me First

Models for U.S.A.

Federal Communications Commission Radio Frequency Interference Statement

Note: This equipment has been tested and found to comply with the limits for a Class

B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to

provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference

to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning the equipment off

and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

l Reorient or relocate the receiving antenna.

l Increase the separation between the equipment and receiver.

l Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

Consult the Panasonic Service Center or an experienced radio/TV technician for help.

Warning

To assure continued compliance, use only shielded interface cables when connecting

to a computer or peripheral. Also, any changes or modications not expressly ap-

proved by the party responsible for compliance could void the user’s authority to

operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the follow-

ing two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, including interference that may

cause undesired operation.

FCC RF Exposure Warning:

l This equipment complies with FCC radiation exposure limits set forth for an uncon-

trolled environment.

l This equipment has been approved for portable operation, and does not require

any minimum spacing be provided between antennas and all person’s body.

l This equipment may not be co-located or operated with any other antenna or

transmitter.

This equipment is provided with external antenna connector(s) for connection to

optional Car Mounter or Port Replicator for mobile external mounted antenna(s).

External antenna(s) must be professionally installed and cannot exceed recommend-

ed maximum antenna gain as described in individual provided supplement instructions

for wireless transmitters. Also, user must maintain minimum 20 cm spacing between

external antenna(s) and all person’s body (excluding extremities of hands, wrist and

feet) during wireless modes of operation.

25-M-2

U1mk2.5_OI_XP7.indb 4 2011/07/06 17:55:31