AirPrime and HL7548 AT Commands Interface Guide Rev10 0

Table Of Contents
4116303 Rev 10.0 August 10, 2017 148
AT Commands Interface Guide
SMS Commands
8.16. +XCMGS3GPP2 Command: Send 3GPP2 SMS
Message
HL7518 and HL7548
Test command
Syntax
AT+
XCMGS3GPP2=?
Response
OK
Write command
Syntax
AT+
XCMGS3GPP2=
<length>
<message_type>
<CR>
PDU is given
<ctrl-Z/ESC>
Response
If sending is successful:
OK
If sending fails:
+CMS ERROR: <err>
Parameter
<length> Indicates the number of total octets coded in the PDU to be given
<message_type> 0 Invalid
1 Point to Point
2 Acknowledge
3 Broadcast
Notes
Entered text should be formatted as follows:
PDU should be in hexadecimal format and given in one continuous line; the
ME/TA converts this coding into the actual octets of PDU.
Sending can be called by giving the <ESC> character during input.
<ctrl-Z> must be used to indicate the ending of PDU.
AT+CMGF has no impact on this command.
This command returns error when SMS over IP network option is not set.
8.17. +XCMT3GGP2 Command: Enable or Disable
the 3GPP2 MT SMS URC
HL7518 and HL7548
Test command
Syntax
AT+XCMT3GPP2
=?
Response
+XCMT3GPP2: (list of supported <n>s)
OK