AT Command Manual for Sierra MC87XX Module
Table Of Contents
- 1: About This Guide
- 2: AT Password Commands
- 3: Modem Status, Customization, and Reset Commands
- 4: Diagnostic Commands
- 5: Test Commands
- 6: Memory Management Commands
- 7: Voice Commands
- 8: GPS Commands
- 9: STK Commands
- Appendix A: Test Frequencies / Channel Lists
- Appendix B: HSDPA / HSUPA Categories
- Appendix C: ASCII Table
- Appendix D: Module Customization
8
Rev 2.9 Oct.08 115
8: GPS Commands
• Introduction
• Command summary
• Command reference Introduction
ThischapterdescribescommandsusedtoaccessGPSfunction‐
alityinsupportingmodules.
Note: The modem must be in ONLINE mode to use these
commands—use AT!DAFTMDEACT to enter ONLINE mode.
Minimum firmware revision
Theminimumrequiredfirmwarerevisionforthecommands
inthischapterisF1_2_0_0.
Command summary
Thetablebelowliststhecommandsdescribedinthischapter.
Table 8-1: GPS commands
Command Description Page
!GPSAUTOSTART Configure GPS auto-start features 117
!GPSCLRASSIST Clear specific GPS assistance data 118
!GPSCOLDSTART Clear all GPS assistance data 118
!GPSENABLE (Deprecated) Enable GPS functionality and MTLR support 119
!GPSEND End an active session 120
!GPSFIX Initiate a GPS position fix 121
!GPSIPADDR Set / query IP address to use over TCP/IP 122
!GPSKEEPWARM Set / clear / query Keep Warm functionality 122
!GPSLOC Return the last known location of the modem 123
!GPSMTLRSETTINGS Set / query MT location request settings 124
!GPSNIQOSTIME Set / query GPS QoS timeout period for network-initialized
fixes
124
!GPSPORTID Set / query port ID to use over TCP/IP 125
!GPSPOSMODE Configure support for GPS positioning modes 126