AT Command Manual for Sierra MC87XX Module
Table Of Contents
- 1: About This Guide
- 2: AT Password Commands
- 3: Modem Status, Customization, and Reset Commands
- 4: Diagnostic Commands
- 5: Test Commands
- 6: Memory Management Commands
- 7: Voice Commands
- 8: GPS Commands
- 9: STK Commands
- Appendix A: Test Frequencies / Channel Lists
- Appendix B: HSDPA / HSUPA Categories
- Appendix C: ASCII Table
- Appendix D: Module Customization
GPS Commands
Rev 2.9 Oct.08 125
!GPSPORTID = <portid>
!GPSPORTID?
Supporting Mini Cards:
• MC8780 / 81 (minimum
FW rev: F1_0_1_4ap)
• MC8785V
• MC8790 / 90V
Set / query port ID to use over TCP/IP
Note: Deprecated.
!GPSSUPLURL
should be used in place of
!GPSIPADDR and !GPSPORTID.
This command sets or reports the port ID of the SUPL server to use when
using TCP/IP as the transport mechanism for SUPL.
Usage:
• AT!GPSPORTID=<portid> queues the request to set the port ID and
returns OK or Error. indicating if the request is successfully queued
• AT!GPSPORTID? returns the port ID currently being used
Parameters:
<port ID> (port ID to use)
• Valid TCP/IP port number
Related commands
• !GPSIPADDR (p.122) — Set/query the IP address to use over TCP/IP
Table 8-2: GPS command details (Continued)
Command Description