AT Command Manual for Sierra MC87XX Module
Table Of Contents
- 1: About This Guide
- 2: AT Password Commands
- 3: Modem Status, Customization, and Reset Commands
- 4: Diagnostic Commands
- 5: Test Commands
- 6: Memory Management Commands
- 7: Voice Commands
- 8: GPS Commands
- 9: STK Commands
- Appendix A: Test Frequencies / Channel Lists
- Appendix B: HSDPA / HSUPA Categories
- Appendix C: ASCII Table
- Appendix D: Module Customization
GPS Commands
Rev 2.9 Oct.08 133
!GPSXTRADATAENABLE =
<enable>
[,<retries>,<retryInt>
[,<dload>, <dloadInt>]]
!GPSXTRADATAENABLE?
!GPSXTRADATAENABLE=?
Supporting Mini Cards:
• MC8780 / 81 (minimum
FW rev: F1_2_0_0ap)
• MC8785V
• MC8790 / 90V
• MC8791V
• MC8792V
Set / query GPS XTRA settings
This command enables or disables GPS XTRA data and sets or reports
GPS XTRA data configuration settings.
Note: These settings are persistent across power cycles.
Note: AT!RESET must be issued after this command is used.
Usage:
• AT!GPSXTRADATAENABLE=
<enable>[,<retries>,<retryInt>[,<dload>,<dloadInt>]] enables or
disables GPS XTRA data. You can only set the retry parameters if
<enable> = 1, and you can only set the download parameters if the
retry parameters are set.
• AT!GPSXTRADATAENABLE? returns the current GPS XTRA data
settings. For example, AT!GPSXTRADATAENABLE? returns:
XTRA Data Enabled: <enable>
XTRA Data Retry Number: <retries>
XTRA Data Retry Interval: <retryInt>
XTRA Data Autodownload Enabled: <dload>
XTRA Data Autodownload Interval: <dloadInt>
• AT!GPSXTRADATAENABLE=? returns supported <enable>, <retries>,
<retryInt>, <dload>, and <dloadInt> values.
Parameters:
<enable> (Enable or disable gpsOneXTRA functionality)
• 0 — Disable
• 1 — Enable
<retries> (Number of download retries)
• 0 — 10
<retryInt> (Interval between download retries, in minutes)
• 1 — 120
<dload> (Enable or disable automatic downloads)
• 0 — Disable
• 1 — Enable
<dloadInt> (Interval between automatic downloads, in hours)
• 1 — 168
Table 8-2: GPS command details (Continued)
Command Description