AT Command Manual for Sierra MC87XX Module
Table Of Contents
- 1: About This Guide
- 2: AT Password Commands
- 3: Modem Status, Customization, and Reset Commands
- 4: Diagnostic Commands
- 5: Test Commands
- 6: Memory Management Commands
- 7: Voice Commands
- 8: GPS Commands
- 9: STK Commands
- Appendix A: Test Frequencies / Channel Lists
- Appendix B: HSDPA / HSUPA Categories
- Appendix C: ASCII Table
- Appendix D: Module Customization
MC87xx Extended AT Command Reference
30 2130616
!NVMUXMODE Query / set USB descriptor MUX mode 44
!NVOEM Query / set values of non-volatile (NV) memory items 45
!NVPLMN Provision the PLMN list for Network Personalization locking 46
!NVPLMNCLR Reset Network Personalization data 46
!NVPORTMAP Change modem port mappings in non-MUX mode 46
!NVSWOC Configure Software on Card feature 47
!PCINFO Return power control status information 48
!PCOFFEN Query / set Power Off Enable state 49
!PCTEMPLIMITS Query / set temperature state limit values 49
!PCVOLTLIMITS Query / set power supply voltage state limit values 50
!PRIID Query / set module PRI part number and revision 50
!REL Query / set active protocol / revision 51
!SCANTHRESH Set / query WCDMA Scan Threshold 52
!SCPROFSWOPT Set / query profile’s software options 52
!SCROPROF Set / query profile’s read-only flag 53
!SLEEP Query / set Sleep Enable state 53
!SWOCMODE Set module operating mode 54
!UOOS Query / set UMTS ‘Out of Service’ parameters 54
Table 3-1: Modem status commands (Continued)
Command Description Page