AT Command Manual for Sierra MC87XX Module
Table Of Contents
- 1: About This Guide
- 2: AT Password Commands
- 3: Modem Status, Customization, and Reset Commands
- 4: Diagnostic Commands
- 5: Test Commands
- 6: Memory Management Commands
- 7: Voice Commands
- 8: GPS Commands
- 9: STK Commands
- Appendix A: Test Frequencies / Channel Lists
- Appendix B: HSDPA / HSUPA Categories
- Appendix C: ASCII Table
- Appendix D: Module Customization
Modem Status, Customization, and Reset Commands
Rev 2.9 Oct.08 41
!MXPORTMAP?
!MXPORTMAP=<mode>
Supporting Mini Cards:
• MC8780 / 81 (minimum
FW rev: F1_1_0_2ap)
• MC8785V
• MC8790 / 90V
Query / set MUX mode port mappings
This command is used to set the modem’s MUX-mode DLCI port
mappings for AT and PDP2.
Usage:
• AT!MXPORTMAP? reports the current port mapping.
For example:
AT!MXPORTMAP? <CR>
00 (or 01)
OK
• AT!MUXMODE=<mode> selects the new port mapping
Parameters:
<mode> (Port map used in MUX-mode):
• 00 = Default
AT uses DLCI port 2
PDP2 uses DLCI port 6
• 01 = Carrier-specific
AT uses DLCI port 6
PDP2 uses DLCI port 2
Table 3-2: Modem status, customization, and reset commands (Continued)
Command Description