User manual

USER MANUAL

Page

• Rectangular areas can be set to display the Maximum, Mean or Minimum

temperatures. Press the M Key to bring up the main menu, then press the ▼ Key to

highlight and select the Setup option, then select “Analysis” by pressing the M or OK

Keys.

• Under the heading named “Area”, you can toggle between “Min”, “Mean” and “Max”

by pressing the◄

► Keys and confirm the selection by pressing the M or OK

Keys.

• It is possible to toggle between one and four measurement areas. Choose the

heading named “Mul Spot/Area” and toggle between “on” and “off” by pressing the ◄

► Keys, then confirm the selection by pressing the M Key. Note, only one area is

present in the “off” position.

• Press the C Key to exit and return to the saved image.

Note:

• Pressing the

•

switches between two modes, for changing area location

and for adjusting area size. Under each mode, pressing the

•

will switch

back to the other.

• The beginning size of the rectangular temperature measurement areas

displayed is the minimum size available and cannot be reduced by the

operator.

Isotherm Sub-menu

• The Isotherm procedure can be performed on live, captured and saved images.

• Press the M or ► Keys to enter the “Analysis” menu. Press the ▼ Key to highlight

and select “Isotherm”, then confirm the selection by pressing the M or OK Keys.