User's Manual

SMAC User Manual
Sify Technologies Limited, 2011 © Copyright Protected Page 11
2 Computer Configuration Instruction
The default operating mode is Outdoor Base for AP hardware and Outdoor Subscriber for SU
hardware. Device will not assign an IP address to the computer/notebook. Therefore, follow the
steps to assign an IP address to your Ethernet card.
2.1 Assign a Static IP
In order to configure SMAC5800, please follow the instruction below:
1. In the Control Panel, double click Network
Connections and then double click on the connection of
your Network Interface Card (NIC). You will then see
the following screen.
2. Select Internet Protocol (TCP/IP) and then click on
the Properties button. This will allow you to configure
the TCP/IP settings of your PC/Notebook
3. Select Use the following IP address radio button and
then enter the IP address and subnet mask. Ensure that
the IP address and subnet mask are on the same subnet
as the device.
4. Click on the OK button to close this window, and then
close LAN properties window.