Owner's Manual

20
21
sigsauer.com
HyperScan MODE
While the rangefinders support single button push ranging operation, it is highly recommended that
you push and hold the RANGE button down to activate HyperScan mode. This mode allows you to
scan targets at 4X/second which significantly improves ranging performance at extreme distances.
As the ranging distances are updated very quickly in HyperScan mode, once you release the RANGE
button the last acquired distance will be displayed. When in HyperScan mode ranging distant targets,
the display may update between no result and a distant range - by using RangeLock technology the
rangefinder will report the last range result when the RANGE button is released.
DISPLAY INFORMATION
The display shows you the center aiming circle, the unit of measure (Y), Angle Modified Range mode
(AMR) and the remaining battery status. The display will remain active for up to 30 seconds , or
whatever timeout has been set within in the SIG BDX App. You can then press the RANGE button to
determine range to target.
If you press the RANGE button while the rangefinder is off and continue to hold the RANGE button
down, the rangefinder will automatically switch into SCAN mode within 1 second.
After determining the distance to the target, the rangefinder will continue to display the center
aiming circle and range data for 30 seconds – and only the range data. All other information is not
shown after initial wakeup to prevent clutter in the field of view.
Display at initial wakeup Display when ranging