User's Manual

IV. TECHNICAL SPECIFICATIONS
Technical characteristics
Includes a 300mAh LiPo battery.
Dimensions (W x H x D): 48 mm x 85 mm x 14 mm
Radio characteristics
Sens’it is SIGFOX Ready Class 0
Frequency: 902-905 MHz
Emission power: 22 dBm
Environmental characteristics
Temperature range: -10°C to +50°C
Maximum relative humidity: 90 %
V. CREDITS
Sens’it is owned by SIGFOX.
Sens’it development has been in partnership with Axible Technologies. Website design is by User Adgents.
Sens’it is assembled in France.
VI. WARNING STATEMENTS
1. FCC:
This device complies with Part 15 of the FCC Rules.
 Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause undesired
operation.
 The radiated output power of the device is far below the FCC radio frequency exposure limits.
Nevertheless, the device shall be used in such a manner that the potential for human contact during
normal operation is minimized.
 Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
 Reorient or relocate the receiving antenna.
 Increase the separation between the equipment and receiver.
 Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
 Consult the dealer or an experienced radio/TV technician for help.
2. IC
English
This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS standard(s).
Operation is subject to the following two conditions: