User's Manual

Mini base station installation
guide
Ref.: MAN/DPL/000
Rev.: 0.2
Date:03/05/2016
© Copyright SIGFOX. All rights reserved Page 10 of 16
7 DEL STATUS
 Green flash => Boot sequence.
 Orange flash => Connection to the SIGFOX CRA for backbone access
 Orange light => Backbone configuration KO.
 Red Flash => Check POE tension
 Red light => Connection to the radio card
 Green light + orange flash according to Ethernet traffic => Operational
8 ANTENNA
This Base station was certified with an Omnidirectional Antenna with a Gain of 5dBi. Only an
omnidirectional antenna with a gain of 5dBi or less can be used.
9 ANTENNA INSTALLATION (OUTDOOR CONFIGURATIONS)
Correct installation Incorrect installation
The antenna must be fixed at the end of the
tube
 The mounting support diameter must be in the range of 40 to 50mm and be hot deep galvanized
inside as well as outside
 The antenna must be fixed by nuts and jam nuts
Installation recommendation:
 Ensure the waterproofness (must be 100%) of the connector with a self-vulcanizing scotch-
seal (rubber mastic tape) , then with and finally with 2 zip tie-wraps
 The tightening of RF connectors must be made manually.