User Manual

SDS1000X-E User Manual
137
WWW.SIGLENT.COM
Automatic Measurement
Perform the steps below and select voltage or time parameters to make automatic
measurement.
1. Press the
Measure
button on the front panel to enter the MEASURE function menu.
At the same, the frequency and period are enabled with the current trigger channel,
the statistics also was enabled.
2. Press the
Source
softkey, and then use the
Universal Knob
to select the desired
channel. Only analog channels that are displayed are available for measurements.
3. To select and display measurement parameters. Press the
Type
softkey, and then
turn the
Universal Knob
to select the desired measurement parameter.
4. Press the
Universal Knob
to add the measurement parameter, the parameters and
value will be shown above the menu, and the statistics status will update.
5. To turn off the statistic function, press the
Statistics
softkey to select
Off
.
The measurement display area can display 4 measurement parameters at most, and the
measurements will arrange according to the selecting order. If add the fifth measurement
parameter, it will delete the first measurement.
Figure 88 Select the Measurement Parameter