User Manual

SDS1000X-E User Manual
176
WWW.SIGLENT.COM
Knob
and the corresponding function software under the menu.
Wave
Type
Parameters
Frequency
Range
Amplitude
(High-Z)
Offset
(High-Z)
Sine
Frequency/Period/Amplitude/High-L
evel/Offset/Low-Level value.
1uHz~25MHz 4mV~6V ± 3.0V
Square
Frequency/Period/Amplitude/High-L
evel/Offset/Low-Level/Duty value.
1uHz~10MHz 4mV~6V ± 3.0V
Ramp
Frequency/Period/Amplitude/High-L
evel/Offset/Low-Level/Symmetry
value.
1uHz~300KH
z
4mV~6V ± 3.0V
pulse
Frequency/Period/Amplitude/High-L
evel/Offset/Low-Level/ Width/ Width
Fine value.
1uHz~10MHz 4mV~6V ± 3.0V
Noise
Stdev/ Mean value.
DC
Offset value.
± 3.0V
Arb
Frequency//Period/Amplitude/High-
Level/Offset/Low-Level value
To set Arb waveform
Press the
Utility
→
Next Page4/4
→
AWG
→
Wave Type
, then select the Arb, and it has two
types:
Stored Arb
Users can edit the Arb through the PC which has installed the EasyWave software .Send
the edited Arbot to the instrument through remote interface, or read from the U disk which
has stored the Arb. Choose
Wave Type
→
Arb
→
Arb Type
→
Stored
, enter the Stored Arb
interface and invoke the waveform in the external storage device.
Built-in Arb
Choose
Wave Type
→
Arb
→
Arb Type
→
Built-in
to enter the following interface,
Rotate the knob to move the cursor, press the knob to select to the desired waveform, and
then return back to Built-in waveform interface.