User Manual
SDS1000X-E Series Digital Oscilloscope -10
Pattern Trigger
Identify a trigger condition by looking for a specied pattern. This pattern
is a logical combination (AND/OR/NAND/NOR) of the two channels. Each
channel can be set a value among High, Low or Invalid.
In the gure below, the selected logic is “OR”, both Channel 1 and Channel
2 are set to “Low.”
IIC Trigger
After setting the serial 1 or 2 to IIC type in trigger menu, you can use
universal knob to set to trigger on start/stop condition, restart, no
ack,EEPROM, or on the read/write frame with specic device address and
data value. During IIC trigger settings, it is essential to set source channel
previously in decode menu.
In the gure below,the trigger condition is set to “Start”, channel 1 is set as
Data signal, channel 2 is set as Clock signal