User Manual
SDS1000X-E Series Digital Oscilloscope -12
Analog input channels. The four channels are marked by different
colors which are also used to mark both the waveforms on the screen and the
channel input connectors.
Press channel button to open the corresponding channel and press again to
turn it off.
Vertical POSITION Set the vertical offset of current waveform.
Turn clockwise to increase the offset while turn anticlockwise to decrease the
offset.
During the modication, the waveform will move up and down and the offset
message at the lower part of the screen will change along. Press down the
knob to quickly reset the offset to zero
Vertical Scale: Set the vertical scale of current waveform.
Turn clockwise to decrease the scale and while turn anticlockwise to increase
it. During the modication, the ‘amplitude’ of the waveform will enlarge or
reduce and the scale message at the right side of the screen will also change.
Press down the knob to quickly switch the vertical scale adjustment modes
between “Coarse” and “Fine”.
Vertical Control
Press the button to open math operation menu under which
the operation of adding, subtracting, multiplying, dividing, FFT, integral,
differential and square root are supported.
Press the button to enable the reference waveform function, thus
to compare the current waveform with the reference waveform to decide
circuit failures. SDS1000X-E supports 2 reference waveforms saving