User Manual

SDS1000X-E Series Digital Oscilloscope -14
Press the button to enter the history mode. In history mode, it can record most 80000 frame waves
This button is a shortcut key for clear function. When the measurement statistics is ON, press the button to clear the count and recount it. When persist is
enabled, press the button to clear persist
Press the button to enter the measurement setting menu. You could set measurement type, statistic function, all measure and gate measure. You can
select as many as four parameters.
In statistic function, the Curent value, Mean, Min, Max, Std-Dev and Count are shown on the screen.In all measure, you could show all the parameters of the
channel you select
Press the button to enter the sample menu. You can set the acquisition mode (Normal/Peak-Detect/Average/Eres), interpolation mode (Sinx/X or linear)
and memory depth. You could enable the XY function and sequence function.
Press the button to enter the le save and recall function menu. The storable le types includes Setups, Waveforms, Picture and CSV.
Press the button to reset the oscilloscope to its default setup. In the le save and recall function menu, user can customize the default setup.
Press this button to save an image of display.
Press it to open decode menu. Decode is a optional function.SDS1000X-E supports two serial buses including 1 and 2 for analog signal decoding. The
protocols includes IIC, SPI, UART/RS232, CAN and LIN.