User Manual

SIGLENT

16 User Manual

: Press the button to enter the CURSOR function menu. The oscilloscope

provides manual and track cursor mode.

: Press the button to enter the DISPLAY function menu and quickly enable the

persist function. User can set the grid, intensity, graticule, transparence.

: Press the button to enter the UTILITY function menu to look at the system

status, do self calibration, set the sound, language and so on.

: The button is a shortcut key for clear function. When the measurement

statistics is ON, press the button to clear the count and recount it. When

persist is enabled, press the button to clear persist.

: Press the button to enter the MEASURE function menu to set the

measurement parameters, all measurement, statistics and set the gate.

: Press the button to enter the ACQUIRE function menu to set the acquisition

mode, memory depth, wave interpolation and so on.

: Press the button to enter the SAVE/RECALL function menu to save setups,

waveforms, pictures, or CSV files to internal memory or USB flash driver.

: Press the button to reset the oscilloscope to user default setup.

: Press the button to enter the history mode. In history mode, it can record

most 80000 frames waveforms. If sequence function is enabled, it only record

the frames which you set, the most you can set is 80000.

: Press the button to enter the DECODE function menu. The oscilloscope

supports I2C, SPI, UART/RS232, CAN and LIN serial bus decode.

: Press the button to turn off or turn on the menu.