User Manual

SIGLENT
User Manual 81
Figure 36
 7 Address & Data — the oscilloscope will be triggered when the following
conditions are satisfied.
 The address’s length must be 7 bits and the address’s value is the same as
set value.
 If you have set either Data1’s or Data2’s value, and the signal has a data is
the same as that value. If you have set both Data1’s and Data2’s value, the
signal should has two consecutive data, the first data’s value is Data1,
second data value is Data2.
(Note: If the data’s value is 0xXX, any data value will be matched)
Figure 37 On the 17th Clock Edge