Data Sheet


Specifications
All specification applies to 10X probe and All the SDS1000CNL Series Digital
Storage Oscilloscopes.
To verify that the oscilloscope meets specifications, the oscilloscope must first
meet the following conditions:
● The oscilloscope must have been operating continuously for thirty minutes
within the specified operating temperature.
● You must perform the Do Self Cal operation, accessible through the Utility
menu, if the operating temperature changes by more than 5° C.
● The oscilloscope must be within the factory calibration interval
All specifications are guaranteed unless noted “typical.”
Inputs
Input Coupling AC, DC, GND
Input Impedance
1MΩ±2% || 16Pf±3Pf,
50Ω+/-2%(SDS1202CNL+ contain this function)
Maximum Input
voltage
400V （DC+AC PK-PK，1MΩ input impedance，
X10），CAT I
Ch to Ch Isolation
(Both channels in
same V/div setting)
>100:1 at 100MHz: (SDS1202CNL+)
>100:1 at 50MHz:(SDS1102CNL)
>100:1 at 35MHz:(SDS1072CNL)
Probe Attenuator 1X,10X
Probe Attenuator
Factors Set
1X,5X,10X,50X,100X, 500X,1000X
Vertical System
Vertical Sensitivity
2mV/div -10V/div(1-2-5 order)
[Except SDS1202CNL+ : 2mV/div -5V/div]
Channel Voltage
Offset Range
2mV –200mV: ±1.6V 206mV - 10V: ±40V
(SDS1202CNL+: 2mV-100mV: ±800mV
102mV-10V: ±40V)
Vertical Resolution 8 bit
Channels 2
Analog 200MHz(SDS1202CNL+)

SIGLENT TECHNOLOGIES Co.,LTD
Add: 3/F, Building No.4, Antongda Industrial Zone, 3rd Liuxian Road, Bao'an District, Shenzhen, 518101, China
Tel: [phone] Fax: [phone] E-mail: [e-mail] Website: www.siglent.com
