User Manual

SIGLENT

User Manual 89

SPI Triggering

This part will provide a brief introduction and description for the operation of the SPI

trigger.

1. Press Setup key to enter the TRIGGER function menu.

2. Press Type and select Serial.

3. Press Protocol and select SPI.

4. Press Trigger Setting softkey.

Figure 40 SPI TRIG SET Menu

5. Press the Trigger Type softkey to select the trigger condition.

Table 2 Menu Explanations of the SPI trigger type

Function

Settings

Explanation

Trigger Type

MISO

Master-In, Slave-Out

MOSI

Master-Out, Slave-In

6. Press the Data Length softkey, and turn the Universal Knob to set the length of a data.

The range of data length is 4 to 96 bits.

7. Set the value of the trigger data.

 Set the value of a bit:

a. Press the Bit Roll softkey to select a bit in data.

b. Press the Bit Value softkey to set the value of the selected bit.

 Set the value of all bits:

a. Press the All Same softkey to set the value of all bits.

Table 3 Menu Explanations of the SPI Bit value

Function

Settings

Explanation

Bit Value

High voltage level

Low voltage level