User Manual

SIGLENT
SSG5000X User Manual 88
2.7 Power Sensor
The SSG5000X can be connected to a USB power sensor via the USB Host interface.
First connect the USB power sensor to the USB Host connector on the rear panel. If
the “Power sensor has been connected!” message pops up on the screen, the
signal source has successfully activated the power meter control option, and you
can always use the power sensor function.
The power sensors currently supported by the SSG5000X are shown in the following
table:
Manufacturer
Model
R&S (Rohde and Schwarz)
NRP6A USB Power Sensor
Keysight
U2000A Series USB Power Sensor
Power meter setting
The power sensor menu can be accessed in one of three ways:
◆ Click the power meter button on the shortcut menu.
◆ Click on the power meter measurement control on the home page.
◆ Switch menus by clicking the menu button or swiping in the Frequency, Level,
or Sweep menu.