User Manual

SIGLENT
SSG5000X User Manual 192
(2) Verify that the RF signal source has been warmed up for at least 30 minutes
before testing.
(3) Check that the performance of the test equipment used meets the requirements.
(4) Ensure that the test equipment used is within the calibration cycle.
(5) Check if the test equipment used is under the working conditions required by its
manual.
(6) Check if all connections are tightened.
7． Pop-up Message:
The instrument may display prompt messages, error messages or state messages
according to the current working status. These messages are displayed to help you
to use the instrument correctly and are not instrument failures.