User Manual

SIGLENT
SSG5000X User Manual 37
2.3 Sweep Setting
When the RF sweep function is enabled, the RF signal is output from the N-type
connector of [RF OUTPUT 50Ω] on the front panel.
Note: The RF signal will be on only when the RF switch is on.
Press SWEEP to enter RF sweep setting.
Sweep State
The sweep state is off by default. The signal generator SSG5000X offers three
different RF sweep types: Freq, Level, and Freq& Level.
Clicking the drop-down box of the sweep state to choose a sweep type:
⚫ Off: Default state. The sweep disabled Close RF sweep function.
⚫ Freq: Enable frequency sweep. The frequency parameter bar refreshes the
current frequency value in real time and the current sweep progress can be
observed on the frequency sweep progress bar.
⚫ Level: Enable level sweep. The frequency parameter bar refreshes the current
level value in real time and the current sweep progress can be observed on the
level sweep progress bar.
⚫ Freq& Level: Enable frequency sweep and level sweep function. The frequency
and level parameter bar refreshes the current frequency and level value in real
time and the current sweep progress can be observed on the frequency and