User Manual

SIGLENT
SSG5000X User Manual 57
Pulse Modulation (PULSE)
Pulse Modulation represents the process of modulating an RF carrier signal with a
pulse signal as a modulated signal.
Pulse State
Select MOD->PULSE->Pulse State to turn Pulse on or off.
Pulse Out
Select MOD->PULSE->Pulse Out to turn Pulse Out on or off. The default is off.
⚫ On: Turn on the pulse output function. At this time, the signal source outputs
the pulse signal generated by the internal pulse generator from the [PULSE IN/OUT]
connector on the rear panel.
⚫ Off: Turn off the pulse output function.
Note: When the modulation source is “Ext”, the pulse output function will be
turned off automatically.
Pulse Source
Select MOD->PULSE->Pulse Source to set “Int” or “Ext”. The default is “Int”.
1. Int
Use the internal LF generator as the modulation signal source for PM. You can set