User Manual

SIGLENT
SSG5000X User Manual 80
1) DHCP
Set the state of DHCP.
Press UTILITY->Interface ->DHCP State, then press ENTER or knob to change the
state.
When the DHCP state is on, the network DHCP server will configure the IP address,
subnet mask and gateway automatically according to the current network condition.
When the DHCP state is off, the IP address, subnet mask and gateway will be
configured by the user.
2) IP Address
Configure the network IP address.
Press UTILITY->Interface ->IP Address, then move the cursor to specified location
and press number keys to input value, finally press ENTER to make the setup
effective.
3) Subnet Mask
Configure the network subnet mask.
Press UTILITY->Interface ->Subnet Mask, then move the cursor to specified location
and press number keys to input value, finally press ENTER to make the setup
effective.