Quick Start Guide

5 SSG5000X Signal Generator
Digital keyboard
The front panel of the RF signal source provides a numeric keypad (as shown below). The keyboard supports English uppercase and lowercase characters, numbers,
and common symbols (including decimal points, spaces, and !, @, #,$, %, ^, &, *), mainly for editing the name of files or folders and setting parameters (refer to
the "parameter setting" section).
Control Keys Description
0
*...#
A<>a
Digit 0 and space bar switch
In the English state, enter the special symbol !, @, #,$, %, ^, &, *. In the digital state,
enter the decimal point
In the digital state, enter the "-" number. In the English state input for case switching
Figure 1- 5 Digital Keyboard
G/ n
dBuV
M/u
uV
k/m
mV
x1
dBm
BACK
SP AC E
ENTE R
When setting the amplitude, press this key to set units as dBuV. When setting the
frequency, press this key to set units as GHz. If the input is a time-related parameter,
press this key to set units as ns
When setting the amplitude press this key to set units as uV. When setting the
frequency, press this key to set the units as MHz. If the input is time-related , press
this key to set the units as us
When setting the amplitude, press this key to select MV as the unit. When setting the
frequency, press this key to select kHz. If the input is a time-related parameter press
this key to select Ms
When setting the amplitude, press this key to select dBm. When setting frequency, the
units selected will be Hz. If the input is time, the units will be set to s
During the parameter or editing process, pressing this key will clear the input of the
active function area and exit the parameter input state
In the parameter input process, pressing this key will end the parameter input and add
the currently set units for the parameter