User Manual

SIGLENT
SSG5000X User Manual 159
4. Turn on RF output
Press RF ON/OFF or press the HOME key back to the main interface, select the RF
block, the white square on the left of ON to enable RF output. When enabled, the
RF ON/OFF key backlight turns green and the RF state in the status bar changes to
blue.
At this time, the [RF OUTPUT 50Ω] connector outputs an RF signal with a frequency
of 3 GHz and amplitude of 0 dBm.
3.2 Correcting Line Loss
Users can correct line loss using the Flatness function combined with a power meter.
Connect the [RF OUTPUT 50Ω] connector of the SSG to the cable under test, and connect
the end of the cable to a power meter. Plug the power meter into the USB port of the
SSG and wait for the power meter connection to complete.
1. Restore factory settings
a) Press UTILITY or the touch screen to set UTILITY -> Setting -> Preset Type->
Default.
b) Press PRESET, or press UTILITY -> Preset.