User Manual

SIGLENT
SSG5000X User Manual 36
with Sensor”, amplitude correction values in the flatness list will be
generated.
Note:
⚫ You should connect a power sensor with the Signal Generator you use. Before
you fill the flatness list with sensor, there’s no need for you to turn on the RF
state or sensor state. Before or after “Fill Flatness with Sensor” executed, the
RF state and sensor state will be turned on or turned off automatically.
⚫ During filling the flatness list, the pop-up message will be shown as below.
You should not remove the power sensor until the process is finished.