User Manual

USER MANUAL
ZIRC
All information are correct at the time of release. Sigma Designs owns the proprietary rights to the information contained herein this document. It may not be
edited, copied or circulated without prior written agreement by Sigma Designs.
© 2011 Sigma Designs, Inc.
RESET TO FACTORY DEFAULT
When set to Factory Default state, ZIRC is not in any network and is in Z-Wave mode. This
feature is generally used to remove ZIRC from its existing network.
Step 1. Press-and-Hold SETUP and INFO for 10 sec
Step 2. Wait for indication.
GREEN Light flashes 3 times indicating Successful operation. ZIRC is now
set to Factory Default.
X3
Flashes 1 time for Successful operation
Step 3. ZIRC is now ready to Learn into a new network. It will transmit up to 17
Frames of Node Info Frame continuously and then stop transmitting.
ZIRC will again transmit up to 17 Frames of Node Info with any key
pressed.
Note:
If ZIRC is not in a network OR in factory default, re-inserting battery OR any key pressed with
activate or deactivate Learn Mode where Node Info will be transmitted continuously. ZIRC will
stop transmitting Node Info if:
- it successfully learned into a successfully, or
- any key is pressed to stop Inclusion Mode, or
- up to 17 frames of Node Info has been transmitted.