User Manual

USER MANUAL
ZIRC
All information are correct at the time of release. Sigma Designs owns the proprietary rights to the information contained herein this document. It may not be
edited, copied or circulated without prior written agreement by Sigma Designs.
© 2011 Sigma Designs, Inc.
SWITCHING BETWEEN Z-WAVE AND INFRA-RED MODES
The Infra- Red standard supported by ZIRC is NEC format with address of 0xCB04.
Switching ZIRC from Z-Wave Mode to IR Mode
Step 1. Press-and-Hold SETUP and RED for 5 sec
Step 2. Wait for indication.
GREEN Light flashes 1 times indicating Successful operation.
X 1
Flashes 1 time for Successful operation
Step 3. YELLOW Light flashes 1 times with any key pressed on ZIRC indicating
ZIRC is in Infra-Red Mode.
X 1
Flashes 1 time for any key pressed
indicating ZIRC is in Infra-Red Mode
Switching ZIRC from IR Mode to Z-Wave Mode
Step 1. Press-and-Hold SETUP and RED for 5 sec
Step 2. Wait for indication.
GREEN Light flashes 1 times indicating Successful operation.
X 1
Flashes 1 time for Successful operation
Step 3. GREEN OR RED Light flashes 1 times with any key pressed on ZIRC
indicating ZIRC is in Z-Wave Mode
X 1
OR
GREEN Flashes 1 time for any key pressed
indicating success in Z-Wave communication
RED Flashes 1 time for any key pressed
indicating failure in Z-Wave communication