User's Manual

ZIPR2 Z-Wave Over IP Gateway
1 1
All information are correct at the time of release. Sigma Designs owns the proprietary rights to the information contained herein this document. It may not be
edited, copied or circulated without prior written agreement by Sigma Designs.
© 2012 Sigma Designs, Inc.
2.3.2.2 Z/IP Local
The settings page allows entering/selecting IP address & UDP port to connect to the Z/IP gateway.
When ‘Refresh’ button is pressed, Z/IP gateway discovery is initiated. Upon completion, the new list of
gateway addresses is shown.
After Initialize is pressed, on successful initialization, the address is shown as “currently configured” and
the port as “busy”. Now the other pages will be populated with network information.
2.3.2.3 Z/IP Portal
The settings page allows the following operations:
• Add a new client
o Enter ‘Client Id’, ‘Client PIN’, rest of the portal configurations and press ‘Add / Update’
button
• Update an existing client
o Select the entry from ‘Unregistered Clients’ or ‘Registered Clients’; update any configuration
and press ‘Add / Update’ button
• Remove a client from ‘Unregistered Clients’ or ‘Registered Clients’
o Select the entry from the list and press ‘Remove’ button corresponding to the list
• Register a client
o Select it from ‘Unregistered Clients’ and press ‘>’ button.