User's Manual

ZIPR2 Z-Wave Over IP Gateway
1 1
All information are correct at the time of release. Sigma Designs owns the proprietary rights to the information contained herein this document. It may not be
edited, copied or circulated without prior written agreement by Sigma Designs.
© 2012 Sigma Designs, Inc.
Progress information for all operations is shown to give immediate feedback to the user.
The network operations are similar to what the PC Controller software can do, and therefore will not be
elaborated here. A quick map of operations to buttons is provided below.
Z
-
W
ave Network Operation
Button(s)
Include nodes
Add Node
Exclude nodes
Remove Node
Include into an existing network
Initiate
Factory Reset
Reset
Network operation buttons are shown based on the role of the attached controller, for e.g. Add Node
will not show for a secondary controller.
2.3.4 Controller
This page also lists all the nodes in the network. The selected node’s endpoints and device classes; and
the selected endpoint’s interfaces are shown. Secure interfaces are shown with a lock icon. Clicking the
arrow on the interface tab reveals the elements within for specific control.