User manual
Table Of Contents
- CONTENTS
- 1 FOREWORD
- 2 PACKAGING CONTENTS
- 3 SAFETY GUIDELINES
- 4 OVERVIEW
- 5 SETTING MODE
- 5.1 Activating the setting mode
- 5.2 Display setup
- 5.3 Button assignment in the setting mode
- 5.4 Brief guide to device settings
- 5.5 Establishing device settings
- 5.5.1 Setting the language
- 5.5.2 Setting the date
- 5.5.3 Setting the time
- 5.5.4 Setting the gender
- 5.5.5 Setting the date of birth
- 5.5.6 Setting the weight
- 5.5.7 Setting the max. HR
- 5.5.8 Setting the training zone
- 5.5.9 Training with training zones
- 5.5.10 Setting up an individual training zone
- 5.5.11 Setting the total running time
- 5.5.12 Setting the total calories
- 5.5.13 Setting the contrast
- 5.5.14 Setting the button tones
- 5.5.15 TURNING THE ZONE ALARM ON AND OFF
- 6 TRAINING MODE
- 7 TRAINING WITH LAPS
- 8 MAINTENANCE AND CLEANING
- 9 TECHNICAL DATA
- 10 Warranty
66
www.sigmasport.com
7 TRAINING WITH LAPS
7.3.4 DISPLAYING VALUES FOR INDIVIDUAL LAPS
7.4 FAQ (FREQUENTLY ASKED QUESTIONS AND SERVICES)
You can re-view the different measured values for the individual laps.
Prerequisite: Your heart rate monitor must be in training mode.
1 Hold down the LAP button until the lap view opens.
A value from the last lap is displayed.
2 Select a lap.
Press the LAP or the START/STOP button to scroll through
the laps.
3 Press the TOGGLE (-) or TOGGLE (+) button to view the
corresponding lap values.
4 Exit lap view.
Hold down the LAP button. The training mode is displayed.
What happens if I remove the chest belt during training?
The watch will no longer receive a signal. The screen will indicate “O”
and after a short period of time the PC 15.11 will go into sleep mode.
Does the SIGMA heart rate monitor completely switch off?
No – only the time and date are displayed in sleep mode so that you can
also use the heart rate monitor as a normal watch. The PC 15.11 uses
very little power in this state.