Operation Manual
Table Of Contents
- CONTENTS
- 1 FOREWORD
- 2 PACKAGE CONTENTS
- 3 SAFETY GUIDELINES
- 4 OVERVIEW
- 5 SETTING MODE
- 5.1 Opening the setting mode
- 5.2 Display setup
- 5.3 Button assignment in setting
- 5.4 Brief guide to device settings
- 5.5 Making device settings
- 5.5.1 Setting language
- 5.5.2 Setting unit
- 5.5.3 Calibration
- 5.5.4 Correction factor
- 5.5.5 Setting date
- 5.5.6 Setting time
- 5.5.7 Setting gender
- 5.5.8 Setting birth date
- 5.5.9 Setting weight
- 5.5.10 Setting HR max.
- 5.5.11 Setting training zone
- 5.5.12 Training with training zones
- 5.5.13 Setting up the individual training zone
- 5.5.14 Setting the total distance
- 5.5.15 Setting total running time
- 5.5.16 Setting total calories
- 5.5.17 Setting contrast
- 5.5.18 Setting button tones
- 5.5.19 TURNING THE ZONE ALARM ON AND OFF
- 6 CALIBRATION & CORRECTION FACTOR
- 7 TRAINING MODE
- 7.1 Opening the training mode
- 7.2 Display setup
- 7.3 Button assignment in the training mode
- 7.4 Functions during the training
- 7.5 Radio link with the R3 transmitter
- 7.6 Starting the training
- 7.7 Interrupting the training
- 7.8 Exiting the training
- 7.9 Training values after the training
- 7.10 Resetting the training values
- 8 MAINTENANCE AND CLEANING
- 9 TECHNICAL DATA
233
US/GB
7 TRAINING MODE
Synchronization
Start the training mode, reset the RC1209 to
zero, your R3 transmitter will synchronize. During
synchronization the word “SYNC” is displayed. The
synchronization is complete, when “SYNC” is no
longer seen in the display.
Message “Too many signals”
This message appears when there are too many
transmitters in the vicinity. In order to resynchronize,
proceed as follows:
1 Move about 10 m away from possible sources of
interference, such as other heart rate monitors,
power lines and antennas.
2 Press any button to remove the message.
3 Press and hold SPEED (+) button until the
training mode is back to normal.
R3 transmitter and RC 1209 are again
synchronized.
Note: The RC 1209 cannot be disturbed after
a successful synchronization.
Press START/STOP button. The running time begins
to run. At the bottom of the display you will see a
stopwatch icon and the measured value title with
light background.
Prerequisite: Your running computer displays the
Training Mode.
7.6 STARTING THE TRAINING