Operation Manual

Page 40
Bike 1–3 & totals
Settings
www.sigmasport.com ROX
®
10.0
ROX
®
10.0
10.3.1 Pairing with the ROX 10.0 GPS
ANT+ pairing (speed, cadence, heart rate, power)
The transmitter to be paired must be activated (by the magnet passing the ANT+
speed or ANT+ cadence transmitters or by putting on the chest belt with the
heart rate transmitter).
Press the
and buttons to select the appropriate transmitter for pairing
and start the pairing process by pressing the
ENTER
button (“Search”).
“Search” appears briefly followed by the transmitterʼs ID. The pairing process is
now complete and the transmitter can be used for training.
Note
Maintain a gap of one to two feet between the transmitter and the ROX 10.0 GPS.
Also ensure that there are no other ANT+ transmitters within a 20 foot radius.
This process assigns the transmitter(s) to a specific bike number (bike 1, 2 or
3). When in training mode, you must manually select the bike number you are
riding (default: bike 1). For additional information, please refer to section „2.5
Synchronizing the Transmitters“
10.3.2 Pairing power meters
Press the and buttons to select “Power Meter Set.” then press
ENTER
.
Press
ENTER
again to trigger the pairing process with the power meter.
Activate your power meter as described by the manufacturer (usually by turning
the pedals or the wheel).
Once the pairing process has successfully completed, you can calibrate the
power zero point automatically or manually. Please note that this is not necessary
for all power meters. For additional information, please refer to the operating
instructions of your power meter.
Note
The zero point is the value that the power meter sends to the ROX 10.0 GPS if
it is not recording any forces. It is important to set the zero point before setting
off or the automatic zero point will be activated. This value is used to calculate all
power data.
IMPORTANT:
To use the power meter’s values, switch to ‘power meter’ under ‘Settings -->
Device --> Power m./Formula’.