User's Manual

161
WARNING
 When the access lamp is lit, take extreme care to prevent the jack from
becoming disconnected. Otherwise, the camera will turn off and the
written data will be lost.
 When you have finished using the
camera, please turn off the camera and
disconnect the plug from the wall socket.
After taking the DC connector off from the
camera body, close the DC connector
cover as shown in the illustration.
MAINTENANCE
 Do not use chemicals or other cleaning agents such as thinners or
benzene for cleaning the camera and lens. Use a clean, soft cloth and
blower to clean the camera and lens. Lens cleaners can be used for
removing fingerprints.
 Use a blower to remove dust and dirt from the color LCD monitor. To
remove fingerprints or other stains from the LCD monitor, wipe the
surface gently with a soft, clean cloth. Do not apply excessive force, as
this could damage the LCD monitor.
CLEANING THE DUST PROTECTOR
Blow away any dust on the dust protector (image sensor protection glass)
using a blower. If there are any fingerprints on the glass of the dust
protector, first blow away any dust using a blower, then gently wipe it using
a soft, clean cloth. If any stubborn stains or dust remains, contact our
service station for cleaning services.
WARNING
 Do not use an aerosol compressed air cleaner. Liquid squirts depending
on the injection angle, which may damage the dust protector.
 Please do not use the blower with a brush. If a brush is attached, it may
scratch the dust protector.