714PC

9.3.1.16 Results

This property provides all of the LBA-PC results, except statistics, in a one-dimensional array of

doubles packaged as a Variant.

The results are loaded into the array in the following order:

1. Quantitative

2. Elliptical

3. Gauss Fit – whole beam

4. Gauss Fit – major axis

5. Gauss Fit – minor axis

6. Top Hat – whole beam

7. Top Hat – major axis

8. Top Hat – minor axis

9. Divergence

This is the same order as listed in sections 3.1.15 through 3.1.19 below under individual results

properties (also the same order as displayed in the LBA-PC Results Window). All results values

will be loaded into the array all the time. Results not enabled in the LBA-PC will be zero. Note

there are three sets of Gauss Fit and Top Hat results. Either the whole beam section, or the

major and minor sections will contain valid results depending on how the LBA-PC is configured.

9.3.1.17 Quantitative Results

These properties provide individual Quantitative LBA-PC results. For more information, see

chapter 6 in the LBA-PC Operator’s Manual.

Property Name LBA-PC Result

QuantFrameTotal Total

QuantApertureFrac % in Aperture

QuantPeak Peak

QuantValley Min

QuantPeakLocX Peak Loc X

QuantPeakLocY Peak Loc Y

QuantCentroidX Centroid X

QuantCentroidY Centroid Y

QuantRadius

QuantBeamWidthX Width X (Width Major)

Operator’s Manual LBA-PC

164