714PC

3.2.3.9 Lens

Click on this box if your camera is fitted with a lens. When enabled the 2D image orientation is

adjusted to depict the image as if the observer is standing and viewing the scene from behind

the camera.

When disabled, the 2D image is oriented as if the observer is standing in front of the camera

looking at the surface of the detector.

3.2.3.10 Special Camera Settings

The Special Camera Settings dialog box contains the electronic parameters that define a camera

to the frame grabber board. All of these values are saved inside of a cameras .cam type file.

We are not going to tell you much about these settings because we don’t want you accidentally

changing something important and running amuck. If you want to experiment with a new

camera type, one that is not in our camera selection list, then we recommend that you call our

Service Department and ask for assistance. We’ll be happy to lend a hand.

Notice: If you change a setting here, and then do a Save Config..., the change will be saved with the configuration

file, and be restored when the configuration file is restored.

3.2.4 Capture... define acquisition method and processing

The Capture dialog box is divided into four areas. These four areas each control different aspects of

the image capturing process. Each area will be discussed separately.

Operator’s Manual LBA-PC

Doc. No. 10654-001, Rev 4.10