714PC

3.2.11 Password Lockout

You can enter a Password that will cause all of the LBA-PC setup functions to become inaccessible.

The password acts as a toggle. Type in the password once and all setup options will become

disabled. Type it in a second time and setup capability will be restored.

The password has been factory set. To find out your password call the Spiricon Service Department

at 435-753-3729 between the hours of 9:00 am and 5:00 pm MST. The password will only be given

out to an authorized individual. An authorized individual is one whose name appears on the original

Purchase Order, the person whose name appears on the completed warranty card, or to an individual

who knows the Purchase Order Number used to make the purchase. It can also be obtained by a

written request on your company letterhead, signed by an officer of the company.

3.3 Pass/Fail... Drop Down Menu Selections

3.3.1 Pass/Fail... enable and define its operation

All pass fail operations are enabled or disabled by checking the Master Enable box.

Figure 42

You can choose what Action(s) will be performed based upon if the results Fails or Passes the

designated tests.

Check the appropriate box to obtain these available actions:

• TTL Pulse: If you want the LBA to send a TTL pulse out the rear J5 connector, pin 1, each

time the Pass/Fail condition is met.

• Beep: If you want the LBA to cause your PC to Beep, each time the Pass/Fail condition is

met.

• Stop Running: If you want the LBA to halt and display the frame that caused the Pass/Fail

condition to be met.

Operator’s Manual LBA-PC