Instruction manual
14
5.3 Programming a RHF circuit
Install the wireless relay.
Congure the address of the corresponding RHF circuit using the DIP
switches from 5 to 8 (default address is 60).
Nota : several wireless relays can have the same address as long as control is
the same (e.g. control of outdoor lighting).
In the technician menu, assign the relay, see page 39.
Program the circuit, see page 25.
Place the master clock in INIT mode, see page 20.
Check good running with the key .
Nota: commands are sent to the wireless relays every hour, any time the
programming is modied and when leaving the menu.
The update of the schedule is sent every hour to the wireless relays. A
wireless relays save a 2-hour schedule. It must receive an update at least
once both hours.
In the case of a bad reception, at the end of two hours of non-reception, no
more steps are executed and the led of the relay becomes red.