Instruction manual

25
8.1 Viewing the circuits
Select the number of the circuit you wish to view with the key.
Select DISPLAY mode with the and keys and validate with the key .
The display of the parameters is xed and
the step numbers ash.
The and keys can be used to scroll
all the program steps.
Use the key to exit from the menu at any time.
The program steps are displayed in the order of the times and then by type:
weekly order, holidays, special and then PC step.
Steps 01 to 99 are indicated with the total number of steps; if the step is
greater than 99 then only the step number from 001 to 500 is displayed.
8.2 Programming the circuits
Select the number of the circuit you wish to program, or modify the
programming with the key.
The circuits can be programmed in the following modes:
- Weekly,
- Holidays,
- Special,
- Public holidays,
- Additional step,
- Astronomical,
- Periodic.
Only the rst 4 modes are accessible from the master clock. All the modes are
accessible from the PC software.
Select PROG mode with the and keys and validate with the
key.
If the rst step is blank, the time ashes.
Enter the time with the and keys
Cir.01:08:02:00 03s
MTWTFS- Weekly 01/12 ú
Cir.01:HH:MM:SS ---ú
MTWTFS- Weekly 01/01ok