Instruction manual
30
10) Programming in Holidays and Special Day mode
The programming of the SIGMA can be modied during a holiday period and
for a special day.
To access this menu, use the key.
It is possible to enter dates for a holiday period or for a special day. By default,
Holidays mode ashes.
Select Holidays or Special mode, and then
validate with the key.
The rst date ashes.
Enter the dates with the and keys
and then validate with the key.
You can enter only one date-to-date series in Holidays mode on the unit, but it
is possible to enter 20 periods with the software on the PC.
Only the next period can be accessed and modied using the Sigma keypad.
If only the start date is entered (= 1 day), then the start date is the same as the
end date.
If the start date is not entered and only the end date is entered, the
programming is not executed.
It is possible to choose Holidays or Special application mode on all the circuits
in a single operation.
If the “ALL CIRC.” Option is validated, the
Holidays (or Special Day) mode will apply on
all the circuits or melodies of the master
clock.
If the “SELECT” or “ALL EXCEPT” option is
validated, it is then possible to enter the
circuit numbers concerned by this
programming either by selecting them one by
one or by omitting them (“all circuits except”).
You must then select the circuits concerned.
Scroll all the circuits with the and
Dates : Holidays ú
10/02Ç25/02 All Ci r c. o k
Dates : Holidays ú
10/02Ç25/02 All Ci r c. o k
Dates : Holidays ú
10/02Ç25/02 Select ok
CIR ÷ 12/20/21ô/---ö
circuit heating ok