Instruction manual

• The “RACK” models must be mounted in 19” cabinet. These components

will provide mechanical, electrical and re protection (only the front panel may

remain accessible).

• IMPORTANT: before any installation, refer to the “technical

characteristics” paragraph.

• Think of making a backup of your programming on the USB key. In case of

incident (breakdown, thunderstorm…), you will just have to restore the backup

to start the time distribution again.

Caution :

• In case of replacement of the CR2032

battery, it is IMPERATIVE to respect the

polarity following the opposite indications.

• There is risk of explosion if the battery is

replaced by a battery of incorrect type.

• Dispose of used batteries according to the

instructions of the manufacturer.