Datasheet

4
Connecting a DV Camcorder
Before setting up the digital video camcorder, verify the
FireWire 2-Port ExressCard driver has been successfully
installed in your system, then follow the procedures
below.
1. Boot up your system.
2. Connect the 4-pin connector of the provided
FireWire 400 (1394a) DV cable to your camcorder.
3. Connect the 6-pin connector to the FireWire 400
(1394a) port.
4. Power on the camcorder. The camcorder should
now appear in Device Manager.
Inserting/Removing Devices
When inserting/removing your FireWire device, hold
the ExpressCard and make sure it does not move around
inside the slot, otherwise, the ExpressCard may loose
connection or could be ejected from the system.
Note: Before removing the FireWire device, use
Windows' Unplug or Eject Hardware/Safely
Remove Hardware feature, located in the taskbar,
to Stop it.
Removing ExpressCard
Before removing the ExpressCard, use Windows' Unplug
or Eject Hardware/Safely Remove Hardware feature,
located in the taskbar, to Stop it.