Manual

67
USA/GB
ROX 9.1
8 PC INTERFACE/SIGMA DATA CENTER
8.3 INSTALLING THE DOCKING STATION
Note: Before connecting the docking station
to your PC, you must have installed the
software supplied. See also Section 8.2
“Installing the SIGMA DATA CENTER”.
1. Connect the docking station supplied to
a free USB port on your PC.
2. Your operating system will automatically
detect new hardware and install the
appropriate driver.
3. Should automatic installation fail, you can
also install the driver manually using your
Device manager. You will find the driver file
on the SIGMA installation CD in the
“Drivers” directory.
4. Windows warns you about an uncertified
driver. Please confirm this window by
clicking “Continue installation”.
5. Start the analysis software and click on
the “connect” button to integrate your
SIGMA ROX.
6. Twist your SIGMA ROX onto the docking
station. The software recognises your
appliance automatically and switches to
“connected” mode (green light on the
docking station).
7. Follow the instructions in the software.
The SIGMA ROX 9.1 is water resistant, which
means that the cyclist can ride in the rain
without any risk to the computer. The buttons
may also be pressed in rainy conditions.
Should water get into the interior of the
SIGMA ROX 9.1, please remove the battery
and dry it on a radiator, for example. After
drying the unit and re-installing the battery,
the SIGMA ROX 9.1 is ready for the road
again.
9 IMPORTANT NOTES/TROUBLESHOOTING/FAQ
9.1 WATERTIGHTNESS OF THE SIGMA ROX 9.1
9.2 CARE OF THE CHEST BELT
The COMFORTEX+ textile chest belt can
be washed in the washing machine at
+40°C/104°F hand wash. Standard
detergents may be used, but please do not
use bleaching agents or detergents with
bleach additives.
Do not use soap or fabric softener. Do not
give COMFORTEX+ for dry cleaning. The belt
and transmitter should not be put in the dryer.
Put the belt to dry out. Please do no wring
or pull apart or hang in wet condition. The
COMFORTEX+ must not be ironed.