User's Manual

Tele

Eye

User

Guide Page 114

Event Handling

Example of Entry/Exit Zone WITHOUT Security Switch Usage

For Entry Zone :

The entry delay is the period of time between entering the surveillance zone and reaching the

transmitter. In order to disarm the system for maintenance or repair, user / installer enters the

surveillance zone, and the delay time starts from the 1

trigger by the 1

alarm sensor (i.e.

Alarm 4) automatically. Note that if user enables recording action, recording action is

automatically activated during entry delay.

The detail procedure is as below:

1) the alarm is at entry delay

2) the 1

trigger is made by Alarm 4 (i.e. user enter the surveillance zone and the entry delay

time begin)

3) 2

, 3

and 4

trigger are made and each entry delay starts respectively

4) user disarms the system for maintenance

For example: If the time for going from Alarm 4 to transmitter is about 8 minutes, Delay 1

should be longer than 8 minutes, while Delay 2 should be longer than the time for going from

security switch to Alarm 2, and so on.

Tel

Eye RX

DISARM

Surveillance zone

Entry

Alarm 4Alarm 3Alarm 2Alarm 1

Delay4Delay3Delay2Delay1

Time line