User's Manual

Tele

Eye

User

Guide Page 115

Event Handling

For Exit Zone :

The exit delay is the period of time for leaving a surveillance zone without making false alarm

(i.e. Alarm 1, Alarm 2, Alarm 3 and Alarm 4). The purpose is to let the user / installer have

enough of time to leave the surveillance zone after the transmitter is armed. User / installer can

set the delay time for each alarm.

The detail procedure is as below:

1) user arms the system

2) the alarm moves to exit delay

3) the 1

trigger is made by Alarm1 (i.e. user leave the surveillance zone and the exit delay

time begin)

4) 2

, 3

and 4

trigger are made and each exit delay starts respectively

5) user waits for any alarm exit delay to expire.

For example, if the time for leaving the surveillance zone is about 8 minutes, user should adjust

the delay time so that Delay 1 = leaving time between transmitter and Alarm 1, Delay 2 =

leaving time between transmitter and Alarm 2, Delay 3 = leaving time between transmitter and

Alarm 3 and Delay 4 = 8 minutes. The alarm will be activated after the exit delay expired. Note

that if user enables recording action, recording action is automatically activated during exit

delay.

Tel

Eye RX

ARM

Surveillance zone

Alarm 4Alarm 3Alarm 2Alarm 1

Delay4Delay3Delay2Delay1

Exit

Time line