User's Manual

Tele

Eye

User

Guide Page 148

Connection with PTZ cameras

F. Connection with PTZ cameras

Tele

Eye RX transmitter built with a RS485 port IN and OUT, you can connect port OUT to

Pan/Tilt/Zoom cameras (in parallel) and connect port IN to keyboard controller. The connection

diagram is shown below.

Setup Procedure

For installation of CCTV monitor, cameras, network setting and connection, please refer to

P.66 of the User Guide.

Step 1: Connect the P/T/Z cameras to the RS 485 OUT port in parallel at the

Tele

Eye RX rear

panel. Connect the P/T/Z cameras to video input port according to each P/T/Z camera

ID.

Note that all P/T/Z cameras should be the same model.

Step 2: Connect the keyboard controller to the RS 485 IN port at the

Tele

Eye RX rear panel.

For keyboard controller setup, please refer to the keyboard controller manual.

Step 3: Configure P/T/Z cameras driver and setting through OSD menu by CCTV monitor.