User's Manual

Tele Eye
RX
User
Guide Page 43
Setup
Tele
Eye RX for Broadband or Narrowband
Internet Connection with Static IP
Step14: Configure the network setting for
Tele
Eye
RX transmitter and your PC if necessary,
such as router/gateway port mapping (select
router/gateway IP as IP provided by your ISP
and the transmitter IP as IP provided by the
router/gateway), firewall, etc. (Please refers
to the manual of your router/gateway.)
Step15: Run WX-30 software at any network PC.
(For details of WX-30 software installation,
please refer to WX-30 Software Guide)
Step 16: Press
[Connect]
icon to pop up the
[Connect Window]. For example, type and
select the following setting :
Broadband Connection :
Phone/IP : 210.17.139.145
Connect Using: TCP/IP Broadband
Password: 000000
OR
Narrowband Connection :
Phone/IP : 210.17.139.145
Connect Using: TCP/IP Narrowband
Password: 000000
Step 17: Press [Connect] icon to connect
your PC and the transmitter. The video
appears on the WX-30 if success. Otherwise,
the [Warning] board will pop up and show
you failure message. For failure case, please
press [Connect]
icon to check that the
connection setting is valid or not.